Page 353 - TesaKatalogen

P l a sti f o r m Shrinking: less
than 1 μm/mm
PLASTIFORM after removal of
the mould Stability:
PLASTIFORM moulding pastes allow print molding of complex internal machined parts, which can physical properties
then be viewed and checked using optical, non-contact measuring equipment. PLASTIFORM mixing allow to produce
pastess» consist of two components, which have to be mixed in equal proportion to ensure proper prints which do
polymerization. The test object to be reproduced by print molding must be perfectly clean and grease- not deteriorate
free before applying Plastiform. with time. They will
BAD neither be affected
Fluid consistency best suited for moulding internal and full prints of small and medium sizes. Medium by surroundings
elasticity (10 % of the core) allows prints to be removed in most cases. Reproduces the finest details – hence usable as
and can be used for indirect inspection of the surface finish by sight comparison with use of master master standards.
roughness specimens. Easily cut with the special cutter. Components with
DAV additives free from
DAV of fluid consistency best suited for moulding internal and full prints of small and medium sizes. chlorine, fluorine
High elasticity (20 % of the core) allows hard prints to be removed such as large re-entrant angle, or sulfur. Being
groove, complex internal shape. Reproduces fine details. Difficult to cut with the special cutter. Print non-toxic and
will be preferably checked as a whole. on-polluting can be
RGX80 used with no special
RGX80 is the hardest product of the cartridge range. Pasty consistency best suited for moulding whole restriction
internal prints having varying sizes. Weak stretching property and elasticity make it appropriate for Temperature 20°C
easily removable moulding prints.
LKAD < 10°C: no more
Malleable consistency best suited for moulding internal, external and sectorial prints of small and me- polymerization
dium sizes. Applied by hand. Low elasticity (from 1 to 2% of the core) makes it convenient for moulding
prints that are removed with ease. Also appropriate for prints held mechanically if desired. Easily cut
with the cutter.

PLASTIFORM Set

PLASTIFORM full case Consisting of:

–– 1 DS50 injection handle
–– 1 Cutter, special with two parallel

blades
–– 1 PLASTIN (200 g)
–– 50 Mixer-Injectors
–– 10 Injector end pieces
–– 1 DN1 spot remover, 400 ml 21 Rings

for mould removal
–– 3 PLASTIFORM BAD 50 ml
–– 3 PLASTIFORM DAV 50 ml
–– 2 PLASTIFORM RGX80 50 ml

06869122 PLASTIFORM Full case Properties BAD DAV RGX80 LKAD
Fluid (2) Fluid (4,5) Pasty Malleable
P-10 Consistency (max 15) 50 20 80 70
Hardness (shore A) Easy Uneasy Easy Easy
Cut using the dual-blade cutter –
Check
– With contact – – Rigid –
– Without contact Flexible Highly Rigid
– Roughness flexible
Elasticity